Entity Viewer should illustrate 1-n... with number on conect
Posted: Fri Jul 04, 2014 4:03 am
The Entity Viewer should illustrate 1-n,n-1,n-n,1... in entity view by putting a number next to the connection point.
The connection point should also be fixable at the level of the component it is relating.
It should also include an auto routing to use 90deg bends and allow the addition of some anchors on the wires and certatin entities.
It would also be nice to save the state of the diagram to png or pdf and to save specific views for later exports.
The connection point should also be fixable at the level of the component it is relating.
It should also include an auto routing to use 90deg bends and allow the addition of some anchors on the wires and certatin entities.
It would also be nice to save the state of the diagram to png or pdf and to save specific views for later exports.